Drill Press Dust Collector

This is one of the handiest accessories ever for the drill press. If you use your drill press to drum sand this is an absolute must. Adjust the hose to any position you like and it will stay right where you put it! Add on nozzles for any type of drill press job! The Drill Press Dust Collector fits most standard table and floor model Drill Presses. Some drill presses may require an extra link to extend the nozzle tip closer to the dust source.

Drill Press Dust Collector Accessories

Extra Hose and Nozzles

Snap-In 2-1/2" Rigid Flex-Lock Adaptor

The adaptor snaps right on to the Rigid Flex-Lock links witch then allows you to attach a 2 1/2" hose to it.

UHMW Mounting Bracket

This mounting bracket can be used to mount Rigid Flex - Lock Hose to your drill press. The UHMW Mounting Bracket bolts to the drill press motor mounting bracket. Some 8" or 10" and some 12" benchtop models needs adapter plate #343 below.

Drill Press Dust Collector Adaptor Plate

The drill press dust collector adaptor plate is used for drill presses that are to small to allow the dust collection system to attach properly. It fits directly on to the motor mount to project the setup outward from the machine.

4" to 21/2" Reducer

4” to 2½” allows you to reduce from a 4” hose down to a 2½” hose. Hose clamps are required for this type of connection or the small end accepts a standard 2¼” Shop-
Vac® hose end. Only one hose clamp is required on the opposite 4” end for this type of connection.

2 1/2" Splice Fitting

Splice fittings are used simply to connect two sections of dust collection hose together. You can use them on long runs of hose line or short runs of hose line. Hose clamps are required for proper connection . The 2-1/2” fitting will accept a 2-1/4” Shop-Vac® hose. This will allow you to join two Shop-Vac® hoses end to end with no hose clamps.